Artelac Splash moisturizing eye and contact lens solution with sodium hyaluronate 0.24% bottle 10 ml

• The solution is ideal for wearing both soft and hard contact lenses throughout the day.
• Hyaluronic acid (sodium hyaluronate), which is part of Artelac Splash, is a natural moisturizer with a high ability to bind to water.
• “Artelac Splash” moisturizes the eyes for a long time and helps stabilize the tear film to ensure a healthy condition of the eye surface.

For instant relief and hydration for mild to moderate dry eyes caused by:

• lifestyle and the influence of environmental factors, such as prolonged computer work and, as a result, infrequent blinking, staying in an air-conditioned room, cigarette smoke, strong wind;
• systemic diseases, eye surgery, or taking certain medications, such as contraceptives, antihistamines, beta-blockers, antispasmodics, and diuretics.

To eliminate discomfort when wearing hard and soft contact lenses.

1 ml of solution contains: hyaluronic acid in the form of sodium salt (sodium hyaluronate) – 2.4 mg, potassium chloride, sodium chloride, disodium phosphate dodecahydrate, sodium dihydrogen phosphate dihydrate, water for injection.

Contains no preservatives.

It is recommended to instill one drop of Artelac Splash into the conjunctival sac of each eye as needed.

1. Before each use of the solution, remove the translucent white protective cap. Do not touch the tip of the vial with your fingers.
2. Place the bottle tip down and press the pump mechanism several times until a drop appears. Place your thumb on the ergonomic stand and use your other fingers to grip the bottom of the bottle. Place two fingers on the bottom of the bottle.
3. To instill the solution, tilt your head back slightly, gently pull back your lower eyelid with the finger of your free hand, hold the bottle vertically above your eye with the tip pointing down, and gently press the pump mechanism to instill the solution. Close your eyes and slowly move them from side to side to distribute the liquid over the surface of your eye.

When wearing soft and hard contact lenses, you can instill “Artelac Splash” into the conjunctival sac without removing the lenses.

Do not allow the tip of the bottle to touch your eye or touch it with your fingers to prevent contamination of the solution.

After each use, close the bottle with the cap.

Do not use the drug if the bottle is damaged.

In case of combined use with ophthalmic drugs, it is recommended to observe a pause of at least 15 minutes between instillation of the “Artelac Splash” solution and the use of eye drops.

Eye ointments should always be used after instillation of the Artelac Splash solution.

Hypersensitivity to any of the components of the solution (local allergic reactions that occur in isolated cases). In such cases, the use of the drug should be discontinued.

Store at a temperature of + 1 °C to + 25 °C out of the reach of children.

Expiration date:

• in closed original packaging – 2 years;
• after opening the bottle – 6 months.